Come riparare una vecchia pompa dell'acqua – Cosa devi fare quando smette di funzionare!


Translating…

Yesterday the electricity to our sixty year old home here in Sarasota went out the very first time in all these many years thanks to Nature. In the end the water pump chose to take a break from us too. Therefore, I made a decision to talk about a jewel of knowledge with the world regarding how to repair an older water pump motor before you decide to pay the plumber.

The issue with this water pump happened when the electricity had been reinstated to the home. The pump motor was not functioning though electricity had been renewed to it. We called our uncle nearby to help recover the pump motor and therefore started the learning procedure: priming a water pump.

This is exactly what I discovered:

First, My uncle couldn’t repair the pump. Rather, we had an older gentleman from down the street come show us how you can get it done:

You will find evidently two methods to prime the pump and many things you ought to watch out for.

First switch off the pump, whether there’s a charge or you have to disconnect the pump motor.

One. Unscrew the top bolt on the water container itself and put water in to the hole till it either gets to the top of the hole or even starts to gush back out of the water container.

If you’re unable to effectively unscrew the top bolt of the old water container because of the age and rusting of the water container go to step two.

Two. Unscrew the Pressure Meter or control device in the water pump device itself and put water in to the opening till it can be seen at the top of the hole.

Be aware: Just do step one or two, not each together. There should be just one opening uncovered.

Three. After doing actions one or two, reactivate it.

Water ought to gush in the opening that you simply unscrewed. This is known as priming the pump motor, whenever you place water back to the pump motor to get rid of the air in the pump motor so the pump motor could work correctly: moving water and never air.

Should this method not really work then you can have an extra issue, one which I experienced.

Based on the neighbors when electricity is out in a home it might interrupt the “air valve” about the water container.

To check on with this, what you ought to do is actually find the air control device. Unscrew the air control device just in the little tube. Clearly mentioned: the little tube must stay attached to the water pump motor by itself but not to the air control device.

Subsequent, prevent the starting of this little tube by putting your hand over it in which the air control device was previously and try priming the pump motor once more with water and switching this on to see if it really works.

When the pump motor will gush water from the pit from step one or two this means that your own air control device may be the issue and it must be changed.

Air valves aren’t costly. Therefore, don’t worry. They’re about 10 to 15 bucks from any nearby home improvement store.

Substitute your own air control device completely and there you are! Prime the pump motor and you’re simply in business!

Hope this can help!